Peugeot 308 Key Fob Replacement





Peugeot's 308 is a little old but it's attractive. It's not the most luxurious car in its class but an Ford Focus or Volkswagen Golf will protect you from sloping surfaces - but it's a relaxed and pleasant driving experience.





We often receive requests from Coded Car Keys to replace peugeot key fobs. No matter if the issue is persistent or intermittent these tips will aid.





Water Damage





If you accidentally drop your key fob in a puddle, or if it gets wet while kayaking canoeing, rafting or canyoning the fob is more likely to be damaged by water. The best way to stop this from happening is to keep it in a dry bag whenever you're out in the open or engaging in activities that require the fob to be exposed to excessive amounts of water.





It's also important to make sure the fob has completely dried out prior to opening it to use it again. If you detect any odors from the fob (such as industrial liquid or windshield washer fluid), this is another sign that it has been submerged.





A circuit board that is wet could cause the battery's charge to drop its charge or even explode. If you are able to get your keyfob 308 out of the water and turn it upside up and shake as much water as you can prior to opening the casing. After you open it, take off the battery, and then clean the circuit board using an alcohol-soaked cotton swab. 90-percent isopropyl alcohol.





Other reasons your Peugeot 308 remote entry keyless system may not function include a dead battery in the coin-cell or receiver module issue, signal interference or a malfunctioning chip. If none of the above are the cause, you can try resetting the system by disconnection of the battery at 12 volts for approximately 15 minutes.





Dead Coin Battery





Peugeot cars come with a remote start system that allows the driver to start the car from afar and then warm up or cool down the vehicle prior to stepping inside. This feature is extremely beneficial, especially during cold winter months. The remote start system can stop working for a variety reasons, such as the dead battery in the coin-battery.





The coin-shaped battery that is within the key fob may last between two and four years based on how frequently it is used, where it was purchased, and the way it is utilized. Its use-by date is typically printed on the packaging or listed in the instruction manual.





If the key fob stopped functioning after being exposed to pure tapwater, you need to remove the battery and clean the electronic chip using the aid of a towel soaked in isopropyl ethanol. Then, dry the chip thoroughly before replacing. In the event of exposure to soapy or salty water, the chip might be damaged and you'll need to replace the key fob in total.





If you're unsure if the battery is defective it is possible to check the voltage using a multimeter that is connected to both the plus and minus terminals. If the voltage is lower than 12-13 volts, you must replace the battery. Alternately, you could try to reset the on-board computer by disconnecting the 12 volt battery for a short period of time, and then reconnecting it in reverse order (positive cable first followed by negative). The engine should be able to start after this.





Faulty Receiver Module





If you aren't seeing the "Key Detected" It could be that your receiver module is malfunctioning. It's that part that sends an indication to the car when your key fob is activated that also acts as an immobiliser. It stops it from starting until the correct key is in place.





This can be due to several reasons, such as water damage or just aging. If the electronic chip in your Peugeot 308 keyfob has been damaged due to dirty tap water It could be because the keyfob was in contact with it. In this instance, you'll need to take it out and thoroughly clean it using isopropyl or an electronic cleaner. Once it's dry you can put the battery back in and test it again.





If the issue is not resolved, it is a good idea to see the local Peugeot expert or locksmith. They'll be able to make use of a diagnostic device to assist in identifying the problem and fix it.





It is stressful to lose your peugeot 107 key fob replacement car key. A qualified auto locksmith can solve the problem within minutes. They can program your car and cut a fresh, functioning key for you. Click here to find a local locksmith near you.





Electronic chip that is malfunctioning





The electronic chip inside the Peugeot 308 key fob is a very important component of the remote control system. If it gets damaged, your car may not start or receive a message that reads "anti-theft active". If this occurs, the only solution to fix the issue is to obtain a new key. Fortunately, professional auto locksmiths can offer the service within the shortest period of time.





The chip inside the chip of your peugeot 307 replacement key cost 308 key fob can become faulty due to sweat, water damage dirt, or other causes. If your peugeot 207 car key replacement key fob has been exposed soapy or dirty water, it must be cleaned as soon as possible. You can use a paper towel and isopropyl alcohol to clean the electronic component. Then, you need to allow the battery to completely dry.





Radio interference can cause the key fob's functionality to cease. This can be caused by other devices that operate at the same frequency as your Peugeot key fob. This can be caused by bad conditions or objects near to the vehicle. If you have this issue, it is best to visit a peugeot 2008 key fob dealership.





The Peugeot 307 Key Programming key fob 207/308 is extremely delicate and requires special care. You should not drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset all the on-board computers by disconnecting the 12 volt battery for a short period of time. Make sure you disconnect the negative cable first, then the positive.